Data from Germany's Ifo Institute shows that 55% of electrical enterprises are struggling with a shortage of skilled workers, and labor costs have risen by over 20% in the past decade. This crisis presents a historic opportunity for leading ...

The following is a brief introduction to the insulation class of oil immersed transformers and the temperature standard of oil immersed transformers. Insulation class of oil immersed transformer The oil immersed transformer has a class, a...

The inrush current of the transformer only flows through one side of the transformer. Therefore, it can not be balanced in the differential drop through the current transformer. Under normal working conditions, this current is very small and...

1. Short circuit the "input" and "output" terminals of the transformer, and test the insulation resistance between them and the ground wire with a megger. When measured by 1000V megger, the resistance is greater than 2m Ω. 2. The section wi...

The same name terminal of oil immersed transformer specifies that the terminal where the induced current flows into the coil and the positive terminal of mutual inductance voltage in another coil are called the same name terminal of two coup...

The test items required for the transformer factory test are transformation ratio, group, direct resistance, no-load, load, capacity, power frequency withstand voltage, inductive withstand voltage, insulation resistance, dielectric loss, par...

The International Electrotechnical Commission (IEC) is the earliest International Electrotechnical Standardization Organization established in the world, which is responsible for international standardization in the field of electrical engin...

Pole transformers are distribution transformers mounted on electrical service poles. Pole transformer is a common distribution transformer used to convert distribution voltage into 120 / 240 V power supply for household and small capacity co...